5-7 pages report

Note:

I need complete 5-7 pages paper on the following assignment. HALF PAGE LENGTH IS NOT ACCEPTED. Must address the all steps properly.  Must include 5 credible references cited in APA.  Must provide 100% original work.

DO NOT PROVIDE THE PREVIOUSLY USED WORK.

DO NOT WRITE QUESTIONS IN ANSWER!

Assignment

The results of your systems analysis and design work in this class will be documented in a Final System Report.  The purpose of the Report is to inform management of your system proposal and gain approval to proceed with the project.  The Report will be developed and submitted in stages, which will be compiled at the end of class into the Final System Report.  Review the outline of the Final System Report in the Stage 4 Assignment description.  Note that it contains the analysis of the problem(s) and requirements, and proposes what kind of a system solution is needed.  It does not propose a specific solution, but it does recommend why and how the organization should acquire the solution.

The first step in the analysis process is to create a Preliminary Investigation Report (PIR).  The PIR documents the system planning phase of the System Development Life Cycle (SDLC).  During the planning phase, the opportunities presented or problem(s) to be solved with an information technology system are identified, investigation into the current situation occurs, and various feasibility aspects of implementing a system are analyzed.  This results in a recommendation for further action with estimated costs and schedule, and a list of benefits.  Once it is completed and approved, the PIR becomes the major source document for use to begin the systems analysis phase.

To start, read the case study carefully.  The case study tells you that the executives at Precision Electronics Parts, Inc., have identified a need to replace the current customer billing and payment system and re-engineer the associated processes. As you review the case study, list the most important relevant business problems and identify the information presented that you will need to complete the sections of the Preliminary Investigation Report shown below.  All of the information you need to complete the projects in this class is not provided in the case study.  In the discussion area of the classroom, there is a discussion titled "Case Study Interview Questions" where you can pose questions about the case study, as if you were interviewing the people in the case study organization.  Any information that you need that is not included in the case study should be asked about in this discussion.  Responses from the faculty member on behalf of the case study organization will be available for everyone in the class. 

Using the case study and the outline and resources listed below; develop complete 5-7 pages Preliminary Investigation Report.  Approximate lengths for each section are provided as a guideline; be sure to provide all pertinent information.  References in brackets are to the two e-textbooks (by authors Jawahar and Conger) used in this class and the page on which the explanatory information begins.

You need to follow this format in your report.

I.                    Introduction (1 paragraph)

a.       Brief statement of the problem or system

b.      Name of person or group who initiated the investigation

c.       Name of person or group who performed the investigation

II.                  Problem to be solved – The basis of the system request, including an explanation of major problems or opportunities (1 paragraph)

III.                Findings

a.       Scope of proposed system (1 paragraph describing the system boundaries – what is included, perhaps where it stops)

b.      Constraints (1 paragraph, including a short list of constraints) [Jawahar, p. 61]

c.       Fact Finding – significant findings and conclusions (1 paragraph with more than one finding and conclusion to be drawn; source is the case study and responses to questions posed in the Case Study Interview Questions discussion)

d.      Current Costs – cost of current system (1 short paragraph; source is the case study and responses to questions posed in the Case Study Interview Questions discussion)

IV.                Feasibility Analysis: This is not a complete Feasibility Report; instead it is a discussion of whether and how the proposed systems is technically, financially and organizationally feasible.  Describe what aspects of the organization in the case study and the proposed system make it technically, financially and organizationally feasible.  [Jawahar, p. 65]

a.       Technical Feasibility (1 paragraph)

b.      Financial Feasibility (1 paragraph)

c.       Organizational/Behavioral Feasibility (1 paragraph)

V.                  Recommendation for further action

a.       An estimate of how long it would take to implement the system and have it available for use, and a rough cost estimate for the entire project (short paragraph with estimated time and cost)

b.      Expected benefits – tangible (with estimated quantification) and intangible benefits (introductory paragraph and list of tangible (quantified) and intangible benefits) [Conger, p. 148]

Note:

Please make sure you must use the provided sources in references. Other references may include 3 credible sources as required. All sources must be cited in APA.

Required sources

Conger Book: https://onedrive.live.com/?authkey=%21AJ1yszMDzJOaDA4&cid=4C0E8E223AAB604F&id=4C0E8E223AAB604F%219292&parId=4C0E8E223AAB604F%214900&o=OneUp

Jawahar Book: Attached

Case Study: Attached