Engineering Homework Answers & Questions

• Compare and contrast Kenya`s Drinking Water Standards with EPA and EC Directive of the same

  $10.00

  Engineering

  Waiting for answer

• The mass in the following illustration is guided by the frictionless rail and has a mass of 40 kg. • The spring constant, , is 3000 N⁄m. • The spring is compressed sufficiently and released, such that

  $10.00

  Engineering

  Waiting for answer

• Calculate the output voltage Vout if Vin=sin(10^3t).

  $10.00

  Engineering

  Waiting for answer

• i need this prob soliton

  $10.00

  Engineering

  Waiting for answer

• An exothermic reaction is performed in a bioreactor, attached with a controller which is used to maintain the temperature in the bioreactor between certain limits. During a long time period, the tempe

  $10.00

  Engineering

  Waiting for answer

• A signal transmission system for telephone lines over microwave links consists of of FDM-SSB and FM signaling. Each of the bandlimited signals m (t) has bandwidth of W=6 KHz and modulates carrier si

  $10.00

  Engineering

  Waiting for answer

• I need help. It's about control systems and matlab.

  $10.00

  Engineering

  Waiting for answer

• Signal Processing

  $80.00

  Engineering

  Waiting for answer

• Engineering,Signals and Systems

  $30.00

  Engineering

  Waiting for answer

• Please help answer all questions in one hour! Show all work please

  $60.00

  Engineering

  Waiting for answer

• Quantity Takeoff of 1-10

  $45.00

  Engineering

  Waiting for answer

• 6) a)Determine the forces in the columns if a 1200 lb baby elephant sat in the middle of the rigid beam when there were no temperature stresses present. b) Find the forces in the columns when the elep

  $10.00

  Engineering

  Waiting for answer

• 4) WHat should the magnitude of w be in order to neutralize the compressive stress acting at point A located 6" below the top of the concrete (150 lb/ft^3) column.

  $10.00

  Engineering

  Waiting for answer

• 3)The cantilever with a T cross-section is loaded and left to deflect under w. Later on, a wire BC of diameter (1/8)" and alpha=10*10^-6 is tied to the end B, and, allowed to cool by 60 degrees. Deter

  $10.00

  Engineering

  Waiting for answer

• 2) Determine the force F between the top 6' long beam of the bxd=8"x12" and the bottom 11' long simply supported beam after all deflections have taken place. Given both beams are weightless.

  $10.00

  Engineering

  Waiting for answer

• 1) Determine the forces in the highlighted members (bars GEDC are parallel to HAB)

  $10.00

  Engineering

  Waiting for answer

• System stability and Lyapunov

  $30.00

  Engineering

  Waiting for answer

• Lyapunov function question, I will appreciate the help even it is just a part

  $40.00

  Engineering

  Waiting for answer

• Control and Lyapunov function

  $40.00

  Engineering

  Waiting for answer

• when steam is dumped into a vessel contains water?

  $10.00

  Engineering

  Waiting for answer

• Please answer the attached file, thank you.

  $10.00

  Engineering

  Waiting for answer

• in the attachment below

  $25.00

  Engineering

  Waiting for answer

• Please help me in the final exam of ME 50105 Hybrid & Electric Transportation. Check the left link to find what this course is about. The Final exam will be started at 3:30PM on Tuesday, December

  $250.00

  Engineering

  Waiting for answer

• Urgent, please help

  $25.00

  Engineering

  Waiting for answer

• Figure Q1(b) shows a cubical block of 30 cm side slides down along an inclined plane at a velocity of 26 ms-1. The plane is inclined at 30° to the horizontal on which there is a film of oil having dyn

  $10.00

  Engineering

  Waiting for answer

• Need basic ladder logic for this assignment. This is a beginner PLC class

  $45.00

  Engineering

  Waiting for answer

• 1、The vector from the origin to point A is given as (6, −2, −4), and the unit vector directed from the origin toward point B is (2, −2, 1)/3. If points A and B are ten units apart, find the coordinate

  $10.00

  Engineering

  Waiting for answer

• full-wave converter used as an inverter in Fig. 4-14 has an ac source of 240 V rms at 60 Hz, R = 10 Ω, L = 0.8 H, and Vdc = −100 V. The delay angle for the converter is 105°.

  $10.00

  Engineering

  Waiting for answer

• The Acme Corporation is a new startup that wishes to sale their new phone to the public called Acmephone, a more secure version of the phone to business organizations, called the Acmephone B+, and hig

  $10.00

  Engineering

  Waiting for answer

• i) The student is required to determine and briefly explain the type of contract used related to the project. ii) Parties involved related to the project. iii) List of earthwork and main structural wo

  $10.00

  Engineering

  Waiting for answer

• Plz answer me

  $10.00

  Engineering

  Waiting for answer

• Find the Autocorrelation and cross correlation in the Gold code sequence used in CDMA: 1 0 0 0 0 1 0 0 1 0 1 1 0 0 1 1 1 1 1 0 0 0 1 1 0 1 1 1 0 1 0 ( 1+x 3 +x 5 , seed 00001) shift by 2 bits. 0 1 0 0

  $10.00

  Engineering

  Waiting for answer

• 1. In a pneumatic telemetering system, explain how the air flow through a nozzle in a transmitter is varied. How does this variation cause a change in the signal to the receiver? 1. Sketch

  $10.00

  Engineering

  Waiting for answer

• Question in File All subparts

  $40.00

  Engineering

  Waiting for answer

• Question in File

  $40.00

  Engineering

  Waiting for answer

• The radial component of the radiated power density of an antenna is ⃗⃗⃗⃗⃗⃗⃗⃗⃗⃗ = ⃗⃗⃗⃗ = 0 2 ⃗⃗⃗⃗ ( / 2) where 0 is the peak value of the power density, is the usual spherical coordinate, and ⃗⃗⃗⃗ is t

  $10.00

  Engineering

  Waiting for answer

• Determine

  $10.00

  Engineering

  Waiting for answer

• Question is in file

  $60.00

  Engineering

  Answered

• Question in File If you could put numbers in the equations so as to know how to get the final answers

  $50.00

  Engineering

  Answered

• Question in File

  $50.00

  Engineering

  Answered

• Thermofluids

  $10.00

  Engineering

  Waiting for answer

• engineering

  $10.00

  Engineering

  Waiting for answer

• Question in file

  $40.00

  Engineering

  Answered

• the question is in the attachment below

  $20.00

  Engineering

  Waiting for answer

• Part a - c in photo (d) For the rest of the problem we change Vin to 10V. Solve the linear circuit with the Thevenin as defined by Vin = 10V, and the diode linearized to vD0 = 0.63 V to determine vD1

  $10.00

  Engineering

  Waiting for answer

• how to evaucate an ac system

  $10.00

  Engineering

  Waiting for answer

• I need to do a project for my EEE 120 class on quartus and need some help. Are you familiar with the program and able to do that kind of work? Looking for a tutor to help me along the way on this proj

  $150.00

  Engineering

  Waiting for answer

• Any three electrical problems found on any three motor vehicles.how to solve the problems and submit documentation in this regard Range:any three electrical problem,eg,any lights,wiper motor,hooter,ci

  $50.00

  Engineering

  Waiting for answer

• This is for a digital logic course. I need the desired outcome in the attached assignment (this will further be implemented into a 0-59 counter in vivado).

  $80.00

  Engineering

  Waiting for answer

• I have a project for my EEE120 class, Must be familiar and have quartus. I'm looking for a tutor to help me with my project. I don't need someone to do the project completely for me but help me work

  $100.00

  Engineering

  Waiting for answer