Part 3- Ohm’s Law  1.    Set the power supply to 2.5V.  Connect the power supply to R1 as shown.  Record the...

Part 3- Ohm’s Law 

1.    Set the power supply to 2.5V.  Connect the power supply to R1 as shown.  Record the voltage across R1.  Calculate the current using Ohm’s Law.  Measure the current flowing through R1.  Remember that voltage is “across” the resistor and current is “through” the resistor.  Current must be measured in series with the resistor.  Record each value in the table.  Take screenshots to confirm your voltage and current measurements.  

2.    Adjust the power supply to 5V and then 10V, and repeat step 1.  Record each value in the table.  

3.    Repeat steps 1 and 2 for each resistor.  Record each value in the table.