Answered You can hire a professional tutor to get the answer.
Question 4 exhaust emission question 5 fuel pressure and flow rate
QuestionAutomotive Diploma – Diagnostic Procedure ReportFormat.zSt. Name. St. No.100578313Group. 118RUOCHEN JINCompetency No. &Title.AURTTR001 Diagnose complex faults in engine management systemsSubmissionAssignment No.15/07/2019Date.1. Scan tool diagnostics List the test procedures when using a Scan Tool to identify Engine DTCsList the test procedures when using a Scan Tool to carryout Cylinder Balance tests. (specification and output)List the engine faults that are able to be identified using Cylinder Balance tests. List the test procedures when using a Scan Tool to identify Engine DTCsFirst, we need found OBD2 port and connect OBD2 connector of the vehicle.Make sure the vehicle should be ignition on but do not start the engine.Choose the correct vehicle. Year, model, engine type and VIN.Wait to the scan tool connect the ECU.Choose current DTC and observe the result.Select delete codeList the test procedures when using a Scan Tool to carryout Cylinder Balance tests. (specification and output)Plug the data cable of scan tool to OBD2 connector of the carTurn the ignition on but do not start the engine.Choose the correct vehicle to be tested by select the make, model ,engine type, year, VIN.Wait to the scan tool communicate with the vehicle.The display will appear 4 option : 2. Live data and actuator test List the test procedures to carryout Scan Tool “Live data” test.List the engine management system faults that are able to be identified using the Scan Tool – Live datafunction.List the test procedures to carryout Scan Tool “Actuator” tests.List the engine management system faults that are able to be identified using the Scan Tool – Actuator testfunction. The DLC (Data Link Connector or Diagnostic Link Connector) is the standardized 16-cavity connectorwhere diagnostic scan tools interface with the vehicle’s on-board computer. The DLC is usually located12 inches from the center of the instrument panel (dash), under or around the driver’s side for mostvehicles. For some Asian and European vehicles, the DLC is located behind the ashtray and the ashtraymust be removed to access the connector. Refer to the vehicle’s service manual for the location if theDLC cannot be found. 3. Detail sensor diagnosis List the test procedure for computer voltage supply and ground wiresList the test procedures for input sensorsList the test procedures for computer output and actuators Procedure Report Template Ver. 1 - 15/9/2015 Page 1 of 2 Automotive Diploma – Diagnostic Procedure ReportFormat. 4. Exhaust emissions List the test procedures required to carry out Engine Vacuum Leak Testing. (specification and output)List the engine faults that are able to be identified using Vacuum Leak Testing.Emission gas analyser test 5. Fuel pressure and flow rate List the test procedures required to carry out “Fuel Pressure and Flow Rate” tests on engine managementsystems.List the fuel system faults that are able to be identified using the fuel pressure and flow rate tester. 6. References Follow APA Style as shown on the Kangan Library website. Procedure Report Template Ver. 1 - 15/9/2015 Page 2 of 2
