What type of dip-slip fault is shown in figure 1a?-Draw a line to indicate the position of the fault in 1a. -Label the “HW” (hanging wall) and “FW” (footwall) on either side of the fault. -Draw half

• What type of dip-slip fault is shown in figure 1a?

-Draw a line to indicate the position of the fault in 1a. 

-Label the “HW” (hanging wall) and “FW” (footwall) on either side of the fault. 

-Draw half-arrows to indicate relative movement of each fault block.

-Did the hanging wall move up or down relative to the footwall?   

-What type of dip-slip fault is this?

• Focus on the offset of the white layer, what type of strike-slip fault is shown in figure 2a?

-Draw a line to indicate the location of the fault and half-arrows to indicate relative movement.

• In figure 3a, the geologic map shows the strike and dip of outcropping sedimentary beds. From these measurements, describe the rock structure that is most likely beneath Earth’s surface, using terms from the following list: anticline, syncline, dome, basin, symmetrical, asymmetrical.